HyLoft 01031 Manuel d'instructions télécharger pdf (Page 2)

Approximate Assembly Time: 30 minutes or less

MOUNTING THE UPRIGHT SUPPORTS

TO THE WALL STUDS

Using a stud finder, locate 2 wall studs that are 32" to 48" center to center apart. Using a pencil,

mark the top mounting hole centers. Make sure holes are level and the same distance from the

floor. Pre-drill the 2 marked holes using a 3/16" (5 mm) drill bit.

IMPORTANT: Unit MUST be installed into wall studs. Do not use wall anchors for mounting directly to

sheet rock.

32"

48"

centers

Fasten vertical tubes of Left & Right Sides(A & B) to top pre-drilled holes

using a 7/16"(11 mm) nut driver or socket wrench, making sure holes are positioned as shown.

Do not fully tighten top screws at this time.

Make sure that Vertical Tubes of Left & Right Sides(A & B) are vertically level (plumb), & drill through

remaining 2 holes in each. Fasten with remaining Lag Screws(C) and fully tighten.

with 1 Lag Screw(C) in each

Page 3 of 12

1 2 3 4 5 6 7 8 9

Pas de commentaire

HyLoft 01031 Manuel d'instructions Page 2